To monitor and operate the screen, use either Pro-face Remote HMI or GP-Viewer EX.
37.18.1.6 Remote Viewer - Pro-face Remote HMI37.1 Use GP-Viewer EX to Display and Operate Display Unit Data over a Network
GP-4G01 is a model without a display.
By using Gateway Mode, you can transfer data over the network for existing systems without an Ethernet interface.
This chapter introduces the functions of the GP-4G01.
To monitor and operate the screen, use either Pro-face Remote HMI or GP-Viewer EX.37.18.1.6 Remote Viewer - Pro-face Remote HMI37.1 Use GP-Viewer EX to Display and Operate Display Unit Data over a Network
Development Process
The procedure when used with Gateway Mode is as follows.
1. Start GP-Pro EX and create a new project file. |
For details on how to start and create projects, refer to the following.
|
2. In the Device/PLC Settings, enable Gateway Mode. |
|
3. Set up the Device/PLC settings to match the device or PLC |
Refer to the "GP-Pro EX Device Connection Manual". |
4. Transfer project files to the display unit |
|
5. If required, configure WebConfig for your display unit settings. |