Frequently asked Question The sensor or the lamp that is connected to the LT does not respond. What should I do? Check the following 5 items. 1. Is it [Enable I/O] with the LT Editor? 2. Is the LT in the RUN mode? 3. Is the RUN/STOP SW run on the rear side of the LT? 4. Is the wiring correct? 5. Is the logic program correct? Also, if you want to make the state [Enable I/O] at the time of boot, see here.

Return to Top

Back

常见问题 | 个人信息保护 | 关于知识产权 | 使用条款

版权 (C) 2005- Schneider Electric Japan Holdings Ltd.,和普洛菲斯国际贸易(上海)有限公司版权所有，保留所有权利。 沪ICP备05028659号-3