You can check display unit operations with the PLC, without actually connecting the PLC.
This feature is useful in checking and debugging the display unit after changes in PLC device values.
From PLC manufacturer's simulation software (referred to as "external PLC simulator") change PLC device value
On the computer, after changing a device value, you can check display unit operations
33.5.2 Procedure - Checking Display Unit operation and PLC interaction on the Computer
Please run simulation on a computer with the following software installed.
PLC Manufacturer |
Required Software |
Mitsubishi Electric Corporation |
When using MX Component Ver4.12N (hereafter referred to Ver4)
When using MX Component Ver3.16S (hereafter referred to Ver3) |
*1 Must be run before simulation is started.
Operating environments other than those below depend on the simulation software of the device/PLC manufacturer. For details about the operating environment, refer to the manual of the connected device.
PC |
Windows® PC/AT compatible machine |
Operating System |
When using MX Component Ver4
When using MX Component Ver3
|