The installation requirements when installing only the Transfer Tool is as follows.
When the Transfer Tool is installed, the Version Reverter is also automatically installed.
PC |
Windows® PC/AT compatible machine |
Operating system |
32-bit or 64-bit versions of Home, Pro, and Enterprise
All editions of 32-bit or 64-bit versions
All editions of 32-bit or 64-bit versions (Service Pack 1 or later for 64-bit version)
All editions of 32-bit version (Service Pack 2 or later)
All editions of 32-bit version |
Other non operating system programs |
|
Memory |
1 GB or more (2 GB or more is recommended)
128 MB or more (512 MB or more is recommended) |
CPU |
Pentium IV 1GHz or faster
Pentium II 266 MHz or faster is recommended |
Hard disk space*1 |
340 MB or more |
Language |
English, Japanese |
Required equipment |
Required.
Use during installation.
Required when transferring data using USB cables or using the USB storage (Memory Loader).
Required when transferring data via Ethernet. Hub may be required depending on your computer and network card.
A CF Card reader and a PCMCIA conversion card are required when transferring data (Memory Loader) using a CF Card.
Required when transferring data (Memory Loader) using an SD Card.
Required when transferring data via modem. Must support AT commands. |
*1 Free space required for installation.
*2 .NET Framework Ver.2.0 or later is automatically installed on PCs without it. For disk space requirements, visit the Microsoft website.
To install the .NET Framework on Windows 8 or later, a network connection or installation media for the operating system is required. For more details, please refer to the following.
T.2.2.7 Does .NET Framework required appear?
*3 USB cables you can use for transfer operations differ depending on the display unit model.
34.2 Transferring Project Files via USB Transfer Cable
*4 If you use a commercially available CF Card, it may not have been fully tested.
*5 You cannot use modems that need to be connected to the center.