When using the Transfer Tool, refer to the following.
34.12 Settings Guide
When accessing GP-4G01 from a Web browser, refer to the following.40.1.4 WebConfig
To change the GP-4G01 Ethernet settings, access the GP-4G01 from either the Transfer Tool or web browser.
When using the Transfer Tool, refer to the following.34.12 Settings Guide
When accessing GP-4G01 from a Web browser, refer to the following.40.1.4 WebConfig
Initial Value of Ethernet settings
IP Address |
192.168.1.100 |
Subnet Mask |
255.255.255.0 |
Port |
8000 |
Gateway |
0.0.0.0 |
Auto Recognition |
Enable |
Speed Settings |
100M |
Duplex Settings |
Half |
If you forget the IP address settings, you can initialize the Ethernet settings to revert to the default values.
Initialize Ethernet settings
Using a GP-4G01 switch, you can initialize the Ethernet settings.
Except for the power cable, remove all cables from GP-4G01.
Simultaneously hold down both the [USB1 storage eject switch] and [SD card eject switch] for 3 or more seconds. After 3 seconds, the buzzer sounds and the power LED (PWR) flashes green.
Release the touch, and within 30 seconds hold the [SD card eject switch] for 3 seconds or more. After 3 seconds, the buzzer sounds.
Release the touch and initialization of Ethernet settings takes place. Once complete, the buzzer sounds and the power LED (PWR) returns to green.