34.11.1 Operating Systems that support Transfer Tool

The installation requirements when installing only the Transfer Tool is as follows.

When the Transfer Tool is installed, the Version Reverter is also automatically installed.

	Required Specifications	Remarks
PC	Windows® PC/AT compatible machine
CPU	Windows 2000, Windows XP Pentium II 266MHz or faster Windows Vista, Windows 7 Pentium IV 1 GHz or faster
Operating system	Windows 2000 Service Pack 3 or later Windows XP All editions for 32 bit version Windows Vista All editions of 32-bit versions Windows 7 All editions for 32/64 bit versions
Memory	Windows 2000, Windows XP 128 MB or more Windows Vista, Windows 7 1 GB or more	Windows 2000, Windows XP 512 MB or more is recommended. Windows Vista, Windows 7 2 GB or more is recommended
Hard Disk Space	340 MB or more	This capacity is required for installation.
Others	.NET Framework Version 2.0	.NET Framework 2.0 or later will be installed automatically. For disk space requirements, visit the Microsoft website.
CD/DVD drive	Those supported by the above operating systems	Use during installation.
Mouse	Those supported by the above operating systems	Required.
USB Port	Required when transferring data via USB cable. Supported USB cables differ depending on the model. For more details, please refer to the following. 34.2 Transferring Project Files via USB Transfer Cable You can also transfer using the USB Memory Loader
LAN port	Required when transferring data via Ethernet. LAN cable	Hub may be required depending on your computer and network card.
Environment that supports a modem connection (when transferring via modem)	Windows® compatible modem	AT commands must be supported. Modems that need to be connected to the center cannot be used.
CF Card drive	For CF Card transfer (CF memory loader), or reading and writing to a CF Card, a CF Card reader or a PCMCIA conversion card is required. Pro-face CF Card (sold separately)	Needed when transferring to CF card supporting models.
SD card drive	Needed when transferring via SD card (memory loader) or reading and writing data on SD cards. SD card supporting SD or SDHC standards	Needed when transferring to SD card supporting models.