|
|
001 |
Module type error
|
The module setting type is not supported.
|
|
The project file might not have been sent properly. Transfer the project file again.
|
| 002 |
Setting value error
|
The variable type allocated to the terminal is not correct or the terminal settings are not correct.
|
| 003 |
Device out-of range error
|
The variable address allocated to the terminal is not correct.
|
| 004 |
Excess terminal settings
|
The number of terminals is not correct. (Too many terminals)
|
| 005 |
Terminal setting order error
|
The terminal number is not in ascending order.
|
| 006 |
Terminal registry short
|
The number of terminals is not correct. (Too few terminals)
|
| 007 |
Module settings duplicated
|
The module is registered twice.
|
| 008 |
Excess module settings
|
The number of modules is not correct. (Too many terminals)
|
| 009 |
Driver settings duplicated
|
The driver is registered twice.
|
| 010 |
I/O settings inconsistent
|
The terminal settings are not correct (unit I/O settings are not consistent).
|
| 011 |
Bit/Integer type inconsistent
|
The terminal settings are not correct (unit variable type settings are not consistent).
|
| 012 |
Setting level value error
|
The driver is not correct.
|
| 013 |
Data obtaining address error
|
The driver information is not correct.
The controller information is not correct.
|
| 014 |
Driver ID error
|
The driver/unit registry results in an error and have not been registered.
|
| 015 |
Module setting order error
|
The module number is not in ascending order.
|
 |
050 |
I/O board ID different
|
The connected I/O board is not correct.
|
The display type might not be correct. Check the display type and transfer the project file again.
|
| 051 |
Unsupported model error
|
The driver foes not support the model.
|
| 052 |
IO initial error
|
The I/O board initialization fails.
|
The project file might not have been sent properly. Transfer the project file again.
|
| 053 |
IO ROM error
|
There is a problem with the system ROM on the I/O board.
|
| 054 |
IO RAM error
|
There is a problem with the system RAM on the I/O board.
|
| 055 |
IO microcomputer error
|
There is a problem with the microcomputer on the I/O board.
|
| 056 |
IO IF RAM error
|
There is a problem with the system I/F RAM on the I/O board.
|
| 057 |
IO E2PROM error
|
There is a problem with the system E2PROM on the I/O board.
|
 |
100 |
I/O board error
|
The I/O board does not respond.
|
| 101 |
Special IO parameter error
|
There is a problem with the special I/O parameter you set.
|
 |
The parameter is not correct. Reset the parameter and request the parameter change.
|
| 102 |
Acceleration/Deceleration table creation error
|
There is a problem with the special I/O parameter you set.
|
The parameter is not correct. Reset the parameter and request the acceleration/deceleration table creation.
|
 |
200 |
Integer type data read error
|
Reading the integer type terminal data value failed.
|
The project file might not have been sent properly. Transfer the project file again.
|
| 201 |
Bit type data read error
|
Reading the bit type terminal data value failed.
|
| 202 |
Integer type data write error
|
Writing the integer type terminal data value failed.
|
| 203 |
Bit type data write error
|
Writing the bit type terminal data value failed.
|
沪ICP备05028659号-3