Items
Description
Number
Log number
Date
Operation data is displayed in the format that is set in [Operation Log Settings].
Time
Operation time is displayed in the format that is set in [Operation Log Settings].
User ID
User ID that is registered in [User ID Mode] (Add User ID) is displayed. For [Level Mode] (Do not add User ID), this will be blank.
LEVEL
Display the level between 0 to 15 at the time of operation.
Screen
Displays the Screen Number as B** for Base Screens, and W** for Window Screens, at the time of operation.
Parts ID
Displays the Parts ID.
Comment
Displays comments in Parts. If nothing is registered, this will be blank.
Action
Displays the action.
Address
Displays a target address.
IP Address
When using Pro-face Remote HMI to operate the display unit screen, displays the client IP address.
To display the IP address, from the [Common Settings] click [Operation Log Settings], then select the [Add IP address to log when operating from Pro-face Remote HMI] check box.
23.10.2 Operation Log Settings
Sub Info
Address, Action. Sub Info displays when supplemental remarks are needed for the Address or Action.
Prev Value
Displays the previous value.
Chg Value
Displays the changed value. Bit Address displays ON or OFF, Word Address displays a numeric value. The display format of the numeric value differs depends on the display attributes of the parts being used.
Added Info
When recording the operation log, values stored in the specified word addresses will be read. Stores values only when setting up from the [Common Settings] menu's [Operation Log Settings].
23.10.2 Operation Log Settings
In the following cases, values are not acquired. Instead they will be shown as "****".
When reading word address values failed
When invalid addresses or symbols are defined in the Trigger Monitor word address.
When trigger bit was not turned ON when trigger monitor is set.
When the display format is set to BCD and illegal values are stored, data values stored in word addresses are converted and displayed.
When using Indirect Device addresses, instead of the indirect device name, displays the device/PLC name specified by the Device ID. If a Device ID that does not exist is specified, displays questions marks "????".