There are four ways to end the logic monitor as follows.
End with Parts
Using D-Script, turn off bits 0 and 1 of the #L system variable (#L_LogicMonitor).
(Use parts for converting data Instruction addresses such as D-Scripts.)
Since the logic monitor does not allow editing by the user, you cannot use the switch part.
Logic
Use the instruction to turn off bits 0 and 1 of #L system variable (#L_LogicMonitor).
Screen Change
When the screens change, the started-up monitor ends.
Monitor Screen
Touch [End] in each of the logic monitoring and address monitoring screens.
If not changing the screens, click [Back to Previous] to end.
Please note that if there is no screen to go back to , such as when you start up the logic monitor when the initial screen was not on, you will not be able to end the logic monitor.
When the logic monitor and address monitor end, #L_LogicMonitor is zero-cleared.