|
| GP-Pro EX Device/PLC Connection Manual |
|
Please see below for required drivers and the system requirements to use the pass-through function. Please refer to [Pass-Through Function Guide] for installation or settings of the pass-through function. When using the Pass-Through Function by SIMATIC S7 MPI Direct Driver, please refer to [SIMATIC S7 MPI Direct Driver Pass-Through Function Guide]. For details about how to connect to the Display, click the hyperlink in the Driver column to open the manual PDF (portable document format) file for that driver. |
|
Maker |
Driver |
System Requirements |
|
Mitsubishi Electric Corporation
|
The following GPP function software package is required.
|
|
|
YASKAWA Electric Corporation |
The following enginiering tool is required. MPE720 Ver5.38 / Ver6.04 or higher |
|
|
Yokogawa Electric Corporation |
The following programming tools is required. WideField2 R3.01 or higher
Pass-Through Function can be used only Programming port on CPU. |
|
|
The following programming tools is required. WideField2 R3.01 or higher |
||
|
OMRON Corporation |
The following programming support Tool is required. CX-Programmer Version 3.00 or higher |
|
|
The following programming support Tool is required. CX-Programmer Version 3.00 or higher 
If High Performance Unit is written by the Pass Through Function, response of Link Unit temporarily stops and an error may be displayed on the Display. |
||
|
Rockwell Automation, Inc. |
The following programming support Tool is required.
|
|
|
SIEMENS AG |
The following programming tool is required.
|